Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

View DHCP Server and Interface Information

When you configure a tunnel interface on a vEdge router, a number of services are enabled by default on that interface, including DHCP. A vEdge router can act as a DHCP server for the service-side network to which it is connected, assigning IP addresses to hosts in the service-side network. It can also act as a DHCP helper, forwarding requests for IP addresses from devices in the service-side network to a DHCP server that is in a different subnet on the service side of the vEdge router.

To view DHCP server and interface information:

In Releases 16.2 and later

  1. In vManage NMS, select the Monitor ► Network screen.
  2. Locate the device using the Sort options drop-down and the Search box. Or scroll through the list of devices in the device table.
  3. Select the device by clicking its system IP address.
  4. In the screen that opens, select Real Time in the left pane.
  5. Perform one of the procedures below to view specific DHCP server and interface information.

In Releases 16.1 and earlier

  1. In vManage NMS, select the Monitor ► Network screen.
  2. From the Device Groups drop-down list in the left pane, select the device group to which the device belongs.
  3. Choose the options in the Sort by drop-down to sort the device list by status, hostname, system IP, site ID, or personality.
  4. Select the device.
  5. In the right pane, click the Real Time toggle button.
  6. Perform one of the procedure below to view specific DHCP server and interface information.

View Enabled DHCP Server Functionality

To display information about the DHCP server functionality that is enabled on the vEdge router, select DHCP Servers from the command drop-down located in the right pane.

CLI equivalent: show dhcp server

View DHCP Interface Information

To display information about the interfaces on which DHCP is enabled on a vEdge router or vSmart controller, select DHCP Interfaces from the command drop-down located in the right pane.

CLI equivalent: show dhcp interface

Release Information

Introduced in vManage NMS in Release 15.2.
Display of DHCP interfaces added in Release 15.4.

Additional Information

See the Configuring Interfaces article for your software release.

  • Was this article helpful?