Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

Power Supply and Cooling System

The vEdge 2000 router ships with two AC power supplies installed. Read this article to learn more about the AC power supply in the router as well as about the cooling system and airflow through the router chassis.

AC Power Supply in vEdge 2000 Router

The vEdge 2000 router ships with two AC power supplies installed. The second power supply is for redundancy and load-balancing. If one of the AC power supplies fails due to device failure or input power line failure, a single unit is sufficient to power the entire router.

The AC power supply in a vEdge 2000 router is a hot-insertable and hot-removable field replacement unit (FRU). You can remove and replace the power supply in the rear of the chassis without powering off the router or disrupting normal functioning.

Table 1 describes the AC power supply specifications for the vEdge 2000 router.

Table 1: vEdge 2000 Router AC Power Supply Specifications

Item

Specification

AC input voltage

90-264 Vrms

AC input line frequency

47-63 Hz

Maximum output power

800 W

Nominal power consumption

125 Watts

AC Power Supply LEDs

The vEdge 2000 AC power supply has an LED faceplate that displays information about the status of the power supply. Table 2 describes the LEDs on an AC power supply in a vEdge 2000 router.

Table 2: Power Supply LEDs on a vEdge 2000 Router

LED State

Description

OFF

No AC power to all PSU

1Hz Flashing Blue

AC present; only standby output on

Blue

Power supply DC output on and OK

Red

Power supply has failed

0.5Hz Flashing Red*/Blue*

Power supply warning

*Flashing frequency: 1Hz (0.5 seconds Red/0.5 seconds Blue)

AC Power Cord Specifications

The vEdge 2000 router ships with a detachable AC power cord. The power cord has a C13 connector at one end and the other end is specific to the country/locality to which the product is shipped.

Cooling System and Airflow in a vEdge 2000 Router

The cooling system in a vEdge 2000 router consists of four individual fan trays, each comprising a double-stacked fan module (see Figure 1). The fan trays cool the router itself, except the power supply units, which have their own fans for cooling.

The fan tray is a hot-insertable and hot-removable field-replaceable unit (FRU). The fan trays  provide front-to-back cooling, as shown in Figure 4. If one of the fans in a fan tray fails, you can remove the specific fan tray and replace it with a spare fan tray module without powering off the router or disrupting normal functions.  Also, if one of the fans fails, the rest of the working fans will keep the system running indefinitely.

Figure 1: Fan Tray in a vEdge 2000 Router

h00049.png

The fan tray installs horizontally in the rear of the chassis. It has two thumbscrews that serve as handles and also as a mechanism to secure the fan tray to the main chassis.

The air intake to cool the chassis flows through the perforations in the front of the chassis. Hot air exits from the rear of the chassis via the vents provided near the fans. See Figure 2.

Figure 2: vEdge 2000 Router Airflow

h00058.png

Temperature sensors in the chassis monitor the internal chassis temperature. When a single fan/fan tray fails at room temperature, the system can still provide sufficient cooling.

If a fan/fan tray fails or if the ambient temperature inside the chassis rises above the acceptable range, the router raises an alarm. If the temperature inside the chassis rises above the maximum threshold temperature, the router shuts down automatically.

  • Was this article helpful?