Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

Front Panel Components

This article describes the LEDs, reset button, and the SD card slot on the front panel of the vEdge 1000 router. See Chassis Views for the location of all components on the front panel of the router.

LEDs

The vEdge 1000 router has four chassis status LEDs located in the center of the front panel next to the USB ports. See Figure 1.

Figure 1: Chassis Status LEDs in a vEdge 1000 Router

h00009.png

Table 1 describes the LEDs , their color and states, and the status they indicate.

Table 1: Chassis Status LEDs in a vEdge 1000 Router

LED

Color

Status

SYS

Green/Red

  • Off: System is not on
  • Green: System is healthy and operating fine
  • Blinking Green: System is booting up
  • Red: One of the daemons has failed

STATUS

Green

  • Off: OMP is down
  • Green: OMP with vSmart is up

PWR 0

Green/Red

  • Off: Power adapter input 0 is unpowered
  • Green: 12-Volt output is OK on power input 0
  • Red: Fault on power input 0

PWR 1

Green/Red

  • Off: Power adapter input 1 is unpowered
  • Green: 12-Volt output is OK on power input 1
  • Red: Fault on power input 1

Reset Button

The front panel of the vEdge router has a Reset button. The Reset button is recessed to avoid accidentally pressing it while the router is operational. To press the Reset button, use a sharp narrow tool. Table 2 describes the effects of pressing the Reset button.

Table 2: Reset Button Press Behavior

Press Duration

Behavior

Short press

Pressing for two seconds resets and reboots the router.

Long press

Pressing for 10 seconds resets the router and reboots it with factory default configuration.

SD Card Slot

The front panel of the vEdge 1000 router has an SD card slot. The SD card slot has the following specifications:

  • Normal speed bus: maximum 10 MB/second
  • Supported card types: SD, SDHC
  • Was this article helpful?