Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

Create vBond VM Instance on ESXi

To start the vBond orchestrator, you must create a virtual machine (VM) instance for it on a server that is running hypervisor software. This article describes how to create a VM on a server running the VMware vSphere ESXi Hypervisor. You can also create the VM on a server running the Kernel-based Virtual Machine (KVM) Hypervisor software.

For server information, see Server Hardware Recommendations.

To create a vBond VM instance on the ESXi hypervisor:

  1. Launch the vSphere client and Create a vBond VM instance.
  2. Add a vNIC for the tunnel interface.
  3. Start the vBond VM instance and connect to the console.

The details of each step are provided below.

If you are using the VMware vCenter Server to create the vBond VM instance, follow the same procedure. Note, however, that the vCenter Server screens looks different than the vSphere Client screens shown in the procedure.

Launch vSphere Client and Create a vBond VM Instance

  1. Launch the VMware vSphere Client application, and enter the IP address or name of the EXSi server, your username, and your password. Click Login to log in to the ESXi server.

G00138.png

The system displays the ESXi screen.

  1. Click File ► Deploy OVF Template to deploy the virtual machine.

  1. In the Deploy OVF Template screen, enter the location to install and download the OVF package. This package is the vedge.ova file that you downloaded from the Viptela Support webpage. Then click Next.

g

  1. Click Next to verify OVF template details.

  1. Enter a name for the deployed template and click Next. The figure below specifies a name for the vBond instance.

  1. Click Next to accept the default format for the virtual disks.

  1. Click Next to accept your destination network name as the destination network for the deployed OVF template. In the figure below, CorpNet is the destination network.

  1. In the Ready to Complete screen, click Finish. The figure below shows the name for the vBond instance.

​The system has successfully created the VM instance with the parameters you just defined and displays the vSphere Client screen with the Getting Started tab selected. By default, this includes one vNIC. This vNIC is used for the management interface.

Add a vNIC for the Tunnel Interface

  1. In the left navigation bar of the vSphere Client, select the vBond VM instance you just created, and click Edit virtual machine settings.

  1. In the vEdge Cloud – Virtual Machine Properties screen, click Add to add a new vNIC for the management interface. Then click OK.

  1. Click Ethernet Adapter for the type of device you wish to add. Then click Next.

  1. In the Adapter Type drop-down, select either E1000 or VMXNET3 for the vNIC to add. Then click Next.

  1. In the Ready to Complete screen, click Finish.

  1. The vEdge Cloud – Virtual Machine Properties screen opens showing that the new vNIC is being added. Click OK to return to the vSphere Client screen.

Start the vBond VM Instance and Connect To the Console

  1. In the left navigation bar of the vSphere Client, select the vBond virtual machine instance you just created, and click Power on the virtual machine. The vBond virtual machine is powered on.

  1. Select the Console tab to connect to the vBond console.

  1. At the login prompt, log in with the default username, which is admin, and the default password, which is admin.

Additional Information

Bringup Sequence of Events

  • Was this article helpful?