Skip to main content
Cisco SD-WAN
Product Documentation
Viptela Documentation

request software set-default

request software set-default—Set a software image to be the default image on the device (on vEdge routers and vSmart controllers only). Performing this operation overwrites the factory-default software image, replacing it with an image of your choosing. It is recommended that you set a software image to be the default only after verifying that the software is operating as desired on the device and in your network.

Command Syntax

request software set-default image-name


Software Image Name
Name of the software image to designate as the default image on the device.

Output Fields

The output fields are self-explanatory.

Example Output

vEdge# request software set-default 15.3.3 
This will change the default software version.
Are you sure you want to proceed? [yes,NO] yes

Release Information

Command introduced in Viptela Software Release 15.3.3 for vEdge 100 routers only.
Starting in Release 15.4, supported on all routers and on vSmart controllers.

  • Was this article helpful?