Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

tunnel-source

vpn interface ipsec tunnel-source—Configure the source IP address of an IPsec tunnel that is being used for IKE key exchange (on vEdge routers only). To configure the physical interface that is the source of an IPsec tunnel, use the tunnel-source-interface command.

vManage Feature Template

For vEdge routers only:

Configuration ► Templates ► VPN Interface IPsec

Command Hierarchy

vpn vpn-id  
  interface ipsecnumber    
    (tunnel-source ipv4-address | tunnel-source-interface interface-name)

Options

Source Address
ipv4-address
Source IPv4 address of the IPsec tunnel. This is an address in VPN 0 on the local vEdge router.

Example

Configure the source IPv4 address of the IPsec tunnel used for IKE key exchange

vEdge(config)# vpn 1 interface ipsec1 tunnel-source 10.0.5.11

Release Information

Command introduced in Viptela Software Release 17.2.

Additional Information

See the Configuring IKE article for your software release.
ike
tunnel-destination
tunnel-source-interface

  • Was this article helpful?