Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

natpool

vpn interface nat natpool—Configure a pool of addresses to use in NAT translation (on vEdge routers only).

You configure NAT port forwarding on interfaces in the WAN transport VPN (VPN 0).

vManage Feature Template

For vEdge routers only:

Configuration ► Templates ► VPN Interface Cellular (for vEdge cellular wireless routers only)
Configuration ► Templates ► VPN Interface Ethernet
Configuration ► Templates ► VPN Interface NAT Pool
Configuration ► Templates ► VPN Interface PPP

Command Hierarchy

vpn 0 
  interface interface-name
    nat
      natpool range-start ip-address1 range-end ip-address2

Options

NAT Pool Address Range
range-start ip-address1 range-end ip-address2
Define the range of IP addresses to use for the NAT address pool. ip-address1 must be less than or equal to ip-address2. The pool can contain a maximum of 32 IP addresses. The addresses must be in the same subnet as the interface's IP address.

Operational Commands

show ip nat filter
show ip nat interface
show ip nat interface-statistics

Release Information

Command introduced in Viptela Software Release 18.3.​

Additional Information

See the Configuring Transport-Side NAT article for your software release.

 

  • Was this article helpful?