Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

address-pool

vpn interface dhcp-server address-pool—Configure the pool of addresses in the service-site network for which the vEdge router interface acts as DHCP server (on vEdge routers only).

vManage Feature Template

For vEdge routers only:

Configuration ► Templates ► DHCP Server

Command Hierarchy

vpn vpn-id
  interface geslot/port
    dhcp-server
      address-pool prefix/length

Options

Address Pool
prefix/length 
IPv4 prefix range of the DHCP address pool.

Example

Configure the interface to be the DHCP server for the addresses covered by the IP prefix 10.0.100.0/24:

vEdge# config
Entering configuration mode terminal
vEdge(config)# vpn 1 interface ge0/4
vEdge(config-interface-ge0/4)# dhcp-server address-pool 10.0.100.0/24
vEdge(config-dhcp-server)# show full-configuration
vpn 1
 interface ge0/4
  dhcp-server
   address-pool 10.0.100.0/24
  !
 !
!

Release Information

Command introduced in Viptela Software Release 14.3.​

Additional Information

See the Configuring Interfaces article for your software release.

  • Was this article helpful?