Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

zzz-hold-time

vpn 0 interface tunnel-interface hold-time—Set the delay before switching back to the primary tunnel interface from a circuit of last resort (only on vEdge routers with cellular modules). This delay is to ensure that the primary interface is once again fully operational and is not still flapping.

Command Hierarchy

vpn 0
  interface cellularnumber
    tunnel-interface
      hold-time milliseconds

Options

Delay Time
miliseconds
Delay before switching over from using the last-resort circuit back to using the primary tunnel interface. This delay is to ensure that the primary interface is once again fully operational and is not still flapping.
Range: 1000 through 10000 milliseconds (1 through 10 seconds)
Default: 7000 milliseconds (7 seconds)

Operational Commands

show running-config vpn 0

Example

Change the hold time for the circuit of last resort to 10 seconds:

vEdge# show running-config vpn 0 interface cellular0
vpn 0
 interface cellular0
  ip dhcp-client
  hold-time 10000
  tunnel-interface
   encapsulation ipsec
   color lte
   last-resort-circuit
   no allow-service bgp
   allow-service dhcp
   allow-service dns
   allow-service icmp
   no allow-service sshd
   no allow-service netconf
   no allow-service ntp
   no allow-service ospf
   no allow-service stun
  !
  clear-dont-fragment
  mtu                 1428
  profile             1
  no shutdown
 !
!

Release Information

Command introduced in Viptela Software Release 16.2.

Additional Information

last-resort-circuit

  • Was this article helpful?