Skip to main content
Cisco SD-WAN
Support
Product Documentation
Viptela Documentation

tab

tab—Display tabular command output in table even if the table is wider than the width of the screen. If the command output is wider that the screen width, it wraps onto two or more lines. Use the screen-width command to set the screen width, or simply drag the terminal window to the desired size. Changing the screen size by dragging the window overrides the width set by the cli screen-width command.

Command Syntax

tab 

Options

None

Output Fields

The output is self-explanatory.

Example Output

vm1# show interface ge0/1
interface vpn 0 interface ge0/1
 ip-address      10.0.26.11/24
 if-admin-status Up
 if-oper-status  Up
 encap-type      null
 port-type       service
 mtu             1500
 hwaddr          00:0c:29:ab:b7:62
 speed-mbps      10
 duplex          full
 uptime          0:00:49:33
 rx-packets      3
 tx-packets      2
vm1# show interface ge0/1 | tab
                               IF      IF                                                                                            
                               ADMIN   OPER    ENCAP  PORT                              SPEED                      RX       TX       
VPN  INTERFACE  IP ADDRESS     STATUS  STATUS  TYPE   TYPE     MTU   HWADDR             MBPS   DUPLEX  UPTIME      PACKETS  PACKETS  
-------------------------------------------------------------------------------------------------------------------------------------
0    ge0/1      10.0.26.11/24  Up      Up      null   service  1500  00:0c:29:ab:b7:62  10     full    0:00:49:46  3        2 

Release Information

Command introduced in Viptela Software Release 14.1.

Additional Information

notab
screen-width

  • Was this article helpful?